MIDI Sysex Receive Object

[MarioMalidus]

Thank you for your advices!

I did come a small step further:

I tested to send from Ksoloti direct to my MacBook (via Midi USB Cable):

Interesting: in DIN Mode (Object) the USB Midi Led is flashing - but no Midi Message in the Midi Monitor coming in - hmm. But definitly a reaction when I moving my Poti

When changing to “USB Device” on the Ksoloti the USB Connector does not flash anymore - but the Midi signal is going in (Midi Monitor)

[MarioMalidus]

Correction: I have full Midi information from the Ksoloti to the MacBook!
It wasn’t a good idea to use the axolotis DIN Conectors because of the inner circuit. So I did remove the DIN Connectors from my Axoloti.
Now I will try it with an Resistor to the Kemper.

Ksolotis Midi IO works fine!

Thank you for your advices!

[MarioMalidus]

AAAAhh - So close!!
You were right! I found a 500Ohm Resistor. I putted in between MO5 and 5V not much change in Voltage but Kemper Profiler does react.

But now it won’t connect to the software anymore aaaah

So now I have to make a switch to remove the resistor from the circuit??? any other solution?

Regarding Mario

UPDATE: With 250 Ohm now it works fine, KEMPER REACTS AND SOFTWARE DOES RECOGNIZE KSOLOTI -
YIPIEEEEEEE :-)))))))))))